Migrate to Gigabit Ethernet in a Cost-Effective Manner

Used in conjunction with lower cost 1000BASE-T switches, companies can take advantage of the high bandwidth Gigabit Ethernet offers without all of the higher costs.

Transition Networks’s 1000BASE-T to SX/LX converters allow users to extend the bandwidth to those users outside the reach of the 1000BASE-T standard (up to 125 km).

Features

Auto-Negotiation (802.3u) (Copper & Fiber)
Allows devices to perform automatic configuration to achieve the best possible mode of operation over a link.

Transparent Link Pass Through

Transparent Link Pass Through sends a link-loss signal over the fiber, instructing the remote converter to shut down the copper port—thus notifying the end device—while maintaining the fiber link between the two converters.

Automatic Link Restoration

Transition Networks's converters will automatically re-establish link in all network conditions.
Remote Fault Detect

Loopback

This feature puts a converter in a special mode that enables the device to loop back the signal from the RX port to the TX port on either media for testing and troubleshooting purposes.

Pause (IEEE 802.3xy)

Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed.

Remote Firmware Upgrade

DMI - Diagnostic Monitoring Interface
(supported on CGETF1040-110 when an SFP supporting DMI is used.)

DMI models have four functions:

Transmit Power
Receive Power
Transmit bias current
Temperature

Within each function, the device will send a trap (i.e. error) whenever a high or low warning event or a high or low alarm event occurs (for a total of 16 traps).

Specifications:

Standards	IEEE Std. 802.3ab™ and IEEE Std. 802.3™
Fiber Optic Connector Specs
Single Mode	Min TX PWR: -9.5 dBm Max TX PWR: -3.0 dBm RX Sensitivity: -20.0 dBm Max In PWR: -3.0 dBm Link Budget: 10.50 dB
6-position Switch	SW1: Remote Fiber Fault Detect (Down=Enabled)  SW2: Symmetric Pause  SW3: Asymmetric Pause  SW4: Transparent Link Pass Through (UP=Enabled)  SW5: Fiber Auto-Negotiation (Down=Enabled)  SW6: Loopback (Down=Enabled)
3-position Jumper	Hardware: Converter mode is determined by 6-position switch settings  Software: Converter mode is determined by most recently saved on-board microprocessor settings.
Status LEDs	PWR (Power): ON=connection to external AC power  LKF (Fiber Link): ON=fiber connection  RXC (Copper Receive):Flashing=Receiving data on copper link; ON=Copper Link connection  Duplex: ON=Copper Link connection
Dimensions	Width: 0.86" [22 mm]  Depth: 5.0" [127 mm]  Height: 3.4" [86 mm]
Power Consumption	5.4 watts
Environment	See chassis specifications
Shipping Weight	1 lb. [0.45 kg]
Regulatory Compliance	CISPR/EN55022 Class A + EN55024; FCC Class A; CE Mark
Warranty	Lifetime